POKA PREMIUM Wheel Stand

POKA PREMIUM DETAILING EQUIPMENT WHEEL STAND FOR EASY CERAMIC COATING APPLICATION

A stable and precisely finished wheel stand.
A tool used to support work on rims or entire wheels.
Thanks to 3 rollers, you can turn the wheel in any direction without any problem.
The rollers can be set at an angle, supporting the wheel with bail, or horizontally without the use of a bail.
This solution allows you to work on the rims according to your preferences and possibilities.

The stand is made of high-quality, durable 4mm black steel, precisely cut and bent, finally coated with a powder finish, both inside and outside, to provide an additional protective layer against oxidation.
Bottom rollers with a length of 300m and a top with a length of 400mm (total length of the bail is 900mm) will match the rims in size from 14 “to 22”.
High-quality rubber feet keep the stand in one position during all work.
Thanks to the special rear bends, the bail is very stable, even with massive wheels.

The stand is ideal for:
-ceramic coating application
-wheel renovation
-polishing the rims
-painting rims
-cleaning rims

Dimensions:
Length – 59 cm
Width from the wall – 37 cm
Height – 92 cm
The powder protective layer is resistant to moderate watering; however, the steel may corrode if the protective layer is damaged.
Therefore, it is not recommended to fill the stand with heavy water, and after each possible flooding, it should be thoroughly dried.